Advert

Classified Info

Ford Escort MK1 Mexico Rally Replica

Advert ID: 38589 £29,500 GBP


Advert Began: Jul 27, 2017, 18:39
Number of Times Viewed: 14817
  • 20170419_164009.jpg
  • 463237.jpg
  • 463235.jpg
  • 463239.jpg
  • 463240.jpg
  • 463241.jpg
  • 463242.jpg
  • 463244.jpg
  • 463246.jpg
  • 463249.jpg
  • 20170511_173257.jpg
  • 20170511_173345.jpg
  • 20170511_173318.jpg
  • 463248.jpg

Description

As per the title, my Ford 1971 Escort Mk1 Mexico, built 1971 originally in yellow, now done as the Milk Marketing Board replica (Olympic blue and white) known as “ERNIE”.

Ford Cosworth Engine 440BHP, 2 wheel drive fast road/track car. Surprisingly still road legal and Road Tax Exempt !!!. I have owned the car for the last 14 years and it has had 15 previous owners. I will regret doing this but the car must go as I have lost interest in it and I would rather someone else have the pleasure of it rather than it getting older and forgotten in my garage.

The car has been driven from Essex across to the Nurburgring Germany and back several times without incident.

******************* OPEN TO SENSIBLE OFFERS *****************

The spec is as follows:

Engine

The engine fitted to the car at present is a 2.0 DOHC 16V Cosworth Turbo, running on variable boost from 240bhp to around 440bhp. Starting at the top the rocker cover is powder coated and polished, an oil breather has been installed in to the top of the cover with a one way valve on it to stop anything being sucked in. Steel adjustable Vernier’s are fitted to the cams for fine tuning (brand new set in boot). Pace dry sump kit fitted (pump on block), remote oil filter. All oil hoses are steel braided type run internally in the car. There is an easy clean Pace oil catch tank in the boot that holds around 7 litres of oil and an oil breather tank for any fumes that may occur. Group “A” coil pack with rev restrictor (adjustable Omex rev limiter with launch control). Stack fuel pressure transducer fitted to fuel rail and a mechanical fuel gauge fitted to fuel line. Braided PTFE-6 fuel lines throughout (reduced petrol smell over rubber hoses).

Samco type hoses for all water and air pipes. Bailey dump valve (spare GGR Kevlar diaphragm GPA valve). Bespoke intercooler 4x4 standard ends with large core fitted to full width of car 30% bigger than standard 4x4. T4 turbo fitted with a turbo oil filter in turn fitted to a tubular bespoke manifold made by Hayward and Scott. The manifold is ceramic coated and heat wrapped. The T4 turbo is supported with a crane type rose jointed turbo hanger, also made by Hayward and Scott. K&N air filter resides under O/S wing, 3” down pipe with Stack EGT (exhaust, gas, temperature) sensor fitted, also a Stack Lambda Sensor fitted and a spare boss for tuning purposes. Pro Alloy Cosworth large core radiator modified by Pro Alloy to fit MK1 Escort with Pro Alloy twin fan kit.

Pro Alloy expansion tank powder coated in black. Pro Alloy strut brace with bespoke 3 bar map sensor bracket fitted to brace. Lowered alternator bracket with new alternator. Engine has been mounted 2” rear of standard and has been chassis mounted rather than cross member mounted. The turbo is controlled by a 12 position dial which controls the boost via air to air injectors fitted on a bracket on front of the engine via a piggy back board fitted within the ECU. The boost is variable from about 240 bhp to 440 bhp.

For safety the engine has an oil low pressure cut out when or if the pressure drops to low it cuts the ignition. It runs 4 x grey injectors on a modified fuel 4x4 fuel rail. The oil filler cap has been removed and sealed due to dry sump. The engine itself has been ported and polished, line honed, low compression 7:1:1 pistons have been machined for clearance on valves (by Mountune).

The block is a Harvey Gibbs new Motorsport block with oil injectors machined into the underside for piston cooling YBP (Mountune oil jets). New 4x4 water pump. The unused waterway within the block has been seal up with a dowel. 16 row oil cooler with braided hoses. Radiator fans have override switches for extra cooling. 3” ceramic coated down pipe to 3” stainless twin box system with 3” rolled tail pipe made again by Hayward and Scott.

Gearbox and Transmission

Standard T5 gearbox with Quaife internals. AP Cerametallic 6 plate clutch and cover. Hydraulic clutch release. Single piece prop shaft. 7½ inch Cosworth rear diff and GGR poly bush holder on cradle mounted via roll cage fixings. Launch control wired to 1st gear to help traction off the line. Stack speed sensor on diff bolts. Bespoke gear lever and gear knob. Alloy gearbox mount.

Front Suspension

McPhersons strut type front suspension consisting of Leda coil overs, height adjustable only, refurbished by Gaz (refilled and new seals). Rose jointed adjustable compression struts and antiroll bar (soft, medium or hard) 3 x spare rods. Eccentric rose jointed top mounts in alloy. This allows all adjustment to be made to track, camber and toe.

Rear Suspension

Turreted rose jointed full independent rear suspension with Gaz gold adjustable height and damping coil overs. Again allowing all adjustments to be made to track, camber and toe.

A selection of springs are also supplied in pairs:

10“ – 2.25“ @ 500 lb

10” – 2.25” @ 300 lb

10” – 2.25” @ 250 lb

10” – 2.25” @ 200 lb

10” – 2.25” @ 150 lb

8” – 2.25” @ 225 lb

These all fit front and rear coil overs.

Brakes

Pedal box mounted in front foot well fed by 2 x reservoir in engine bay, one to do hydraulic clutch and one to do remote ABS system in boot. Main brake system is the Teves Anti-Lock Braking system (ABS) including ECU as fitted to the Sierra Cosworth. Fitted to the front are AP Racing Pro5000+ four pot callipers with 280mm fish hook fully floating discs with Ferodo pads DS3000. On the rear are Mk5 Escort callipers with NO hand brake, again Ferodo pads are fitted DS2500. Hand brake is hydraulic type with ratchet lock. There is also an AP adjustable bias valve in the car for adjusting the rear brake pressure. Goodridge type hoses to front and rear. AP Racing fluid has been used in the system.

Wheels and Tyres

There are 14 wheels and tyres included.

All Compomotive ML Type as follows (8 spoke Minilite look)

2 x ML 15x8” Split-rims Rear of car fitted with Yokohama Advan 032R 225-50-15 Soft Compound

2x ML 15x8” rims fitted with Yokohama Advan 032R Soft Compound

4 x ML 15x7” rims fitted with Yokohama Advan 048R Medium Compound

2 x ML 15x7” rims fitted with Slicks 19/58/15 Hard Compound (Rear)

2 x ML 15x7” rims fitted with slicks 19/58/15 medium compound (Front)

2 x ML 15x7” rims fitted with Michelin SD7D 20-59-15

Body Shell

Ford Escort Mk1 Mexico. Gartrac steel bubble arches. Air holed front panel. Hillman Imp front indicators and side lights. Pair of Cibie Oscars and a pair of Cibie Super Oscars mounted on alloy bracket. H4 headlamps, HID conversion (not fitted). 10mm Sump Guard. Front towing eye. The shell has been de-locked. Bonnet pins in aero style. Petrol filler cap removed from rear quarter and installed on C pillar on n/s only. Rear Lucas reverse lamp. Rear towing eye. Boot catches are spring type. Mud flaps on alloy brackets. Milk Marketing Board Livery (1973 RAC winning sponsors). Battery cut-out switch. Vented bonnet and central door locking.

Interior

Safety device roll cage with added door bars, diagonals, harness bars and diff carrier bars. B pillar cross bars. A and B pillar stiffeners. Aero style Sabelt harnesses, 6 point on driver side and 4 point on passenger side, although 6 point can be added to passenger side, all in blue. Sparco Pro2000 seats in blue on alloy mounts, driver’s seat is adjustable. Hydraulic hand break with ratchet lock. Helmet net in the rear. Battery and battery cut out isolator in rear. Dry sump lines are heat shielded as they pass through the interior. Omex Rev Limiter with launch control. Alloy navigators foot rest. Twin cowl works style dash, there is also a spare flocked twin cowl dash. Left hand cowl has 3 x gauges; Stack EGT / Lamda / Fuel Pressure. Right hand cowl has Stack Dash ABS warning light, immobiliser and Stack menu buttons. Ford Racing boost gauge, fuses, various switches for Cibie lights, fans and fuel pumps etc. Peltor intercom system. SEC monitor for Cosworth engine management. Electric power steering (variable). 12 position variable boost switch from 240bhp to 440bhp. Launch control button on steering wheel. Battery kill switch. Start button. Hand held fire extinguisher 2kg. Tracker with life time subscription. Thatcham 2 immobiliser.

Boot

Twin spare wheel post with twin spare wheels. Jack. Remote ABS unit. Easy clean dry sump tank (Pace 8 litre). Pro Alloy air separator tank. Tie downs for spare wheels. Fuses for fuel pumps. Single Bosch 044 high performance fuel pump and filter fed by Pro Alloy pro tank with internal swirl pot on mount. There are also spare twin fuel pumps that are not fitted.

Seller Info

Andrew Locke

Member Since:
18 Apr 2017

Halstead, Essex,

Phone: +44 7920 196727

Print Friendly printer friendly

Tell-a-Friend tell-a-friend

Add-to-Favorites add-to-favorites

Report Abuse Report Abuse

Report Sold Report Sold

Seller Notes

Seller Accepts:
1