ALL STEEL 1700 X FLOW LONG ROD ENGINE o miles

1700 all steel long rod x flow engine built around 16  months ago  very sweet engine was installed in my car and only run 5 road miles and changed my mind and bought a 2 litre  its been on test bed since   and  run up  now and then   latest run up was 23 feb 2023   was going to keep it  for retirement car but i cant see me using  it   it has plenty of potential to be a 180-190 bhp motor    lots of new parts purchased from either anderson race engines and burtons engines
77.6mm en40b 12 bolt steel crank, NEW acl mains and big end race bearings, NEW ARP bolts NEW Farndon 5.23 BDA steel rods
NEW Cosworth forged pistons 83.5mm good sourced 711m block chemically cleaned and fresh rebore and faced
Full trough Titan alloy sump
NEW Titan 5 port dry sump pump
BDA ultra light flywheel with NEW AP paddle clutch

NEW Duplex timing gear
NEW  300 cam kit  and followers and cam bearings
NEW Anderson push rods

NEW CJD (the company that took over burton engineering back in the 80 s ) beautiful Full race ultra big stainless valves (largest poss ) head with bronze guides & double springs  all fully ported work of art
NEW Steel rocker gear and spacers
NEW H & H rally distributor
NEAR NEW 70 AMP ALTERNATOR
NEW Twin 45 DCOEs on misab short race inlet manifold with works throttle linkAGE
Tony Law large bore exhaust manifold
NEW Burton dry sump alloy rocker cover

This is a very nice cengine with only test bed  miles only  ready to fit or dyno. Most of this engine the parts are brand new from either Burtons or Anderson Race engines

Lots of money spent
This spec engine would cost around 11k to build now  only selling due to change of direction would suit all applications engine video available bear in mind its not run in yet and has no miles on